[Q96-Q110] Get up-to-date Real Exam Questions for API-510 UPDATED [2024] : Top Exam Collection : http://blog.topexamcollection.com

NEW QUESTION 96
When a vessel is to be entered for an internal inspection which of the following precautions should be observed?

Inspect the vessel for proper electrical grounding

The area should be roped off and no one else is to be working in the area

No hot work permits in the immediate area must be issued until the inspection is complete

OSHA rules should be reviewed and followed where applicable

NEW QUESTION 97
API-510 states that the minimum temperature for a pressure test should be how many degrees Fahrenheit above the minimum design metal temperature (MDMT)?

10°F

30°F

50°F

70°F

NEW QUESTION 98
API-510 requires a hydrostatic test to be performed at what interval during the vessel’s service life?

After each shutdown

Every 5 years

Every 10 years

Only after major repairs

NEW QUESTION 99
What documentation must be reviewed and updated after any major alteration or repair to a pressure vessel as per API-510?

The original design documents

The latest inspection report

The vessel’s operating manual

All relevant documentation, including design, operation, and maintenance

NEW QUESTION 100
A corroded area in a carbon steel vessel is being repaired by using weld overlay (weld build-up).
The vessel surface should be examined by:

MT or PT before welding

MT or PT after welding

MT or PT before and after welding

MT or PT after welding, and UT flaw detection after 24 hours

NEW QUESTION 101
Describe how API-510 ensures that inspectors are qualified and maintain their qualifications over time.

NEW QUESTION 102
Determine in what two ways may the probable corrosion rate for a new vessel be determined before the first internal inspection?

From data collected on vessels providing the same or similar service or from published data on vessels providing comparable service

Employing highly experienced inspectors or engineers

Corrosion tabs and UT readings

Assuming a standard corrosion rate

NEW QUESTION 103
Explain the process and benefits of integrating API-510 inspection standards with ISO 9001 quality management systems.

NEW QUESTION 104
Describe the challenges and strategies for maintaining API-510 compliance in industries with high turnover rates of inspection personnel.

NEW QUESTION 105
The inspection interval between internal or on-stream inspection shall not exceed which of the following?

One half the estimated remaining life or 15 years whichever is less

One half the estimated remaining life or 10 years whichever is greater

One half the estimated remaining life or 10 years whichever is less

One half the estimated remaining life or 15 years whichever is greater

NEW QUESTION 106
When determining the corrosion rate for a new vessel involved in changes in service conditions and the probable corrosion rate cannot be determined by either available data or experience of the owner/user, on-stream determination shall be made.
What is the length of service recommended by API-510?

1000 hours

100 months

1000 days

1000 weeks

NEW QUESTION 107
For proper internal or external visual inspections, surfaces must be:

Hydro blasted

Grit blasted to SA 2

Wire brushed

The type of surface preparation depends on individual circumstances and could be any of the above

NEW QUESTION 108
Which type of corrosion mechanism is not directly addressed in API-510?

Crevice corrosion

Galvanic corrosion

High-temperature hydrogen attack

Atmospheric corrosion

NEW QUESTION 109
What is the minimum temperature of the metal during a pressure test of a 2.125″ thick vessel?

Minimum temperature shall be at least 20˚F above the minimum design metal temperature

Minimum temperature shall be at least 30˚F above the minimum design metal temperature

Minimum temperature shall be ambient temperature but not less than 55°F

Minimum temperature shall be 60°F

NEW QUESTION 110
Discuss the importance of lifecycle management of pressure vessels under API-510 and strategies for effective implementation.