NEUE FRAGE 45
If the project specification DOES NOT state the specific DFT measurement standards, the inspector should use

NEUE FRAGE 46
What is the minimum recommended distance away from an edge that an inspector should take a measurement with a dial-type magnetic pull-off Dry Film Thickness (DFT) gauge?

NEUE FRAGE 47
ISO SA 3 is directly equivalent to:

NEUE FRAGE 48
Prior to using Inspection Tools the inspector must:

NEUE FRAGE 49
Relative humidity is

NEUE FRAGE 50
When the joint NACE/SSPC abrasive blast cleaning standards are specified, the pictures in SSPC VIS 1 can be used as:

NEUE FRAGE 51
You are asked to be the only coating inspector on a small bridge recoating job where existing coating contains lead. The owners’ representative has supplied you with the local code governing the removal and disposal of lead based coatings, however upon reading the document you having great deal of difficulty understanding the technical language.
As a NACE CIP Level 1 Inspector your preferred course of action is to:

NEUE FRAGE 52
What is the minimum spot measurement value allowed by SSPC-PA 2 in each 10 m2 (100 ft2) area?

NEUE FRAGE 53
Conventional spray is a good choice when:

NEUE FRAGE 54
When using the ISO comparator in accordance with ISO 8503, if the surface profile does not directly compare to one of the four segments the inspector should:

NEUE FRAGE 55
When working as a NACE Inspector in a situation where there is a difference of opinion, the Inspector needs to:

NEUE FRAGE 56
Stripe coats are best applied by:

NEUE FRAGE 57
ASTM Standards are applicable:

NEUE FRAGE 58
The least effective method of surface cleaning is most likely

NEUE FRAGE 59
SSPC SP 1 identifies the use of:

NEUE FRAGE 60
Removal of surface contaminants is done by:

NEUE FRAGE 61
How many gauge readings does SSPC-PA 2 require within a 4 cm (1.5 inch) diameter circle?

NEUE FRAGE 62
NACE SP 0178 is a standard for:

NEUE FRAGE 63
You are the NACE Inspector on a job where the Owner’s specification requites you to perform a twice daily check of blast pressure at the nozzle. It is now day 30 on the job and all of your readings have been within compliance. The Contractor complains that these checks taking up much time and in view of the compliant results they are unnecessary.
Your FIRST preferred course of action is to:

NEUE FRAGE 64
The main responsibilities of the inspector are to

NEUE FRAGE 65
When holiday testing is required the Inspector is always required to enforce NACE SP 0188:

NEUE FRAGE 66
Whenever dissimilar metals must join, the most common practice is to

NEUE FRAGE 67
Fine cracks in the surface of a coating that rarely reach the substrate are called

NEUE FRAGE 68
Check abrasive blast pressure with a