NR. 44 You ate the NACE Inspector on a job where NACE No. 2/SSPC – SP 10 has been specified. You are finding the Contractor is leaving mill scale on the on surface and as a result you have been rejecting the blast. The Contractor is very upset and has told you that the standard permits up to 5% of the mill scale to remain and still be in be in compliance with the standard.
Your FIRST preferred course of action is to:

NR. 45 As a NACE Coating Inspector your responsibility with respect to safety is to:

NR. 46 When holiday testing is required the Inspector is always required to enforce NACE SP 0188:

NR. 47 Daily reports are important because:
Select All That Apply

NR. 48 You have just received your NACE CIP Level 1 certification when you are asked to supervise a team of uncertified field pipeline inspectors.
Your FIRST preferred course of action is to:

NR. 49 You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining.
Your FIRST preferred course of action is to:

NO.50 Galvanic corrosion occurs on which of the following substrates:

NR. 51 Using SSPC Vis 1 as a guide when performing a visual inspection of a steel surface prior to surface preparation a NACE Inspector would assign which designations to the surface condition:

NR. 52 Prior to using Inspection Tools the inspector must:

NR. 53 A NACE Coating Inspector is permitted to transport coating material when:

NR. 54 How many gauge readings does SSPC-PA 2 require within a 4 cm (1.5 inch) diameter circle?

NR. 55 What is used to determine compressed air cleanliness?

NO.56 You are the NACE Coating Inspector on an exterior job where the contractor is not using any environmental controls, For the last several hours your reading; indicate the relative humidity is rising and the substrate temperature is dropping. The sky is clouding over and the weather forecast is for evening showers. It is now 4 PM, your readings indicate you have minimally acceptable environmental conditions, however if the current trend continues, you expect to be outside specified conditions soon. The contractor advises you he is going to mix up the next full kit to complete his for the day.
Your FIRST preformed course of action is to:

NR. 57 Dew point is the temperature at which

NR. 58 Common errors that can produce inaccurate readings when using Wet Film Thickness (WFT) gauges include:
Select All That Apply

NR. 59 In the event of a conflict between the project specification and the coating manufactures’ product data sheet, the Inspector’s first course of action should be too:

NR. 60 To achieve consistently accurate results with ALL alt test equipment

NR. 61 ISO SA 3 is directly equivalent to:

NR. 62 Fine cracks in the surface of a coating that rarely reach the substrate are called

NR. 63 Inspection documentation is important because:

NO.64 Which is a component that supplies most of the features and functions of the material?