[Q30-Q50] Pass Your JNCIP-ENT JN0-649 Exam Easily with Accurate PDF Questions [May 16, 2024] : Top Exam Collection : http://blog.topexamcollection.com

NR. 30 Referring to the exhibit, which two statements are correct? (Choose two.)

The host that the route is associated with is multihomed to two leaf nodes.

The route is a Type 1 EVPN route.

The route is a Type 2 EVPN route.

The host that the route is associated with is single-homed to one leaf node.

NR. 31 Your company has expanded into office space across the street. The new office space has a single Ethernet connection connected to an unmanaged switch. You must sort traffic based on the IP address into different VLANs once the traffic arrives on your EX Series switches.
Which mechanism would you use to accomplish this task?

MVRP

filter-based VLANs

Q-in-Q tunneling

dynamic VLANs

NR. 32 Which two port modes are associated with STP? (Choose two.)

alternate port

backup port

designated

root

NR. 33 Which two statements are correct regarding the behavior shown in the exhibit? (Choose two.)

The ge-1/1/0 interface is configured as secondary for Area 0.

The router is an ABR.

The router is not an ABR.

The ge-1/1/0 interface is configured as secondary for Area 100.

NR. 34 When configuring connectivity to a VoIP enabled phone, which two statements are correct?
(Wählen Sie zwei aus.)

The telephone device can signal to the switch which VLAN tag it will place on voice traffic.

The switch can signal to the phone device which VLAN tag it should use for voice traffic.

The switch places voice traffic in the expedited forwarding class by default.

The switch places voice traffic in the best-effort forwarding class by default.

NR. 35 Referring to the exhibit, which two statements are correct? (Choose two.)

BPDUs from the root bridge for VLAN 10 have been received on the ge-0/0/7.0 interface.

DS-1 is the root bridge for VLAN 10.

BPDUs from the root bridge for VLAN 20 have been received on the ge-0/0/7.0 interface.

Default VSTP bridge priority values are configured.

NR. 36 You are troubleshooting connectivity between an EVPN spine switch configured as a route reflector and a leaf node with an IP address of 10.30.100.6.
Referring to the exhibit, what is the problem?

The neighbor 10.30.100.3 statement is missing from leaf1’s configuration.

The spine node is not configured for the family inet NLRI.

The neighbor 10.30.100.6 statement is missing from spine1’s configuration.

The leaf node is not configured for the family evpn NLRI.

NR. 37 You are asked to configure an 802.1X solution that supports dynamic VLAN assignment. In this scenario, which two modes support using vendor-specific attributes (VSAs)? (Choose two.)

static MAC bypass mode

single-secure supplicant mode

multiple supplicant mode

single supplicant mode

NR. 38 Your network has Junos Fusion configured with MX960 routers as aggregation devices (AD) and QFX5100 switches as satellite devices (SO) Which two statements are coned in this scenario?
(Wählen Sie zwei aus)

The AD runs the Junos software for all its connected SDs.

The Fusion extended ports are configured on the SDs.

SDs are added to the AD by configuring the cascade port on the AD.

All SDs connected to a single AD must use the same software version.

NR. 39 In a Layer 2 environment where 802.1X is deployed, which two statements are correct? (Choose two.)

RADIUS messages are exchanged between the supplicant and the authenticator.

RADIUS messages are exchanged between the authenticator and the authentication server.

Extensible Authentication Protocol messages are exchanged between the authenticator and the authentication server.

Extensible Authentication Protocol messages are exchanged between the supplicant and the authenticator.

NR. 40 Which protocol is used for port-level access control and authentication?

MD5

IPsec

802.1x

AES

NR. 41 Referring to the exhibit, which statement is correct when a failure exists on the link between host2 and switch5 on this EVPN-VXLAN fabric?

The switch5 device will send a Type 2 route to all peers.

The switch5 device will send a Type 4 route to all peers.

The switch5 device will send a Type 1 route to all peers.

The switch5 device will send a Type 3 route to all peers.

NO.42 You must provide network connectivity to hosts that fail authentication.
In this scenario, what would be used in a network secured with 802.1X to satisfy this requirement?

Configure the native-vlan-id parameter on the port.

Use the server-reject-vlan command to specify a guest VLAN.

Configure a secondary IP address on the port for unauthenticated hosts.

Configure the port as a spanning tree edge port.

NO.43 Referring to the exhibit, how will router E quickly learn that the remote MAC addresses are no longer reachable through the router attached to the failed link?

Router E receives Type 2 withdrawal messages from router D.

Router E receives Type 1 withdrawal messages from router D.

Router E receives Type 1 withdrawal messages from router C.

Router E receives Type 2 withdrawal messages from router C.

NR. 44 Referring to the exhibit, which two statements are true with regards to deploying CoS? (Choose two.)

You should apply BA classifiers on the point-to point interfaces of the routers.

You should apply MF classifiers on the LAN-facing interfaces of the routers

You should apply BA classifiers on the LAN-facing interfaces of the routers

You should apply MF classifiers on the point-to-point interfaces of the routers

NR. 45 Your IS-IS adjacency is not established as shown in the exhibit. What is the problem?

There is an invalid IPv6 router ID

There is an MTU mismatch

There is an invalid IPv4 router ID

There is an area mismatch

NR. 46 You are redistributing static routes into an OSPF area. Which two statement are true is this scenario? (Choose two.)

The external route advertisements have a domain scope.

The area must be stub area.

The area must be the backbone area.

The routes can be advertised in type LSAs.

NR. 47 Referring to the exhibit, on which three IS-IS routers will the attached bit be set? (Choose three.)

UR5

UR3

R2

R4

R6

NR. 48 Which EVPN route type is used for fast convergence and for advertising the split horizon label?

Type 4

Type 2

Type 1

Type 5

NR. 49 Which statement is correct about IS-IS?

IS-IS uses areas and an autonomous system.

Level 1/2 routers automatically inject a default route to the nearest Level 1 router.

Level 2 routers must share the same area address.

Level 1 routers route traffic between autonomous systems.

NO.50 You are asked to implement fault tolerant RPs in your multicast network. Which two solutions would accomplish this behavior? (Choose two.)

Use BFD with statically defined RPs.

Use MSDP with statically defined RPs.

Use anycast PIM with statically defined RPs.

Use IGMPv3 with statically defined RPs.