Get The Important Preparation Guide With 156-315.80 Dumps [Q196-Q217] : Top Exam Collection : http://blog.topexamcollection.com

NO.196 Which Remote Access Client does not provide an Office-Mode Address?

SecuRemote

Endpoint Security Suite

Endpoint Security VPN

Check Point Mobile

NO.197 SSL Network Extender (SNX) is a thin SSL VPN on-demand client that is installed on the remote user’s machine via the web browser. What are the two modes of SNX?

Application and Client Service

Network and Application

Network and Layers

Virtual Adapter and Mobile App

NO.198 Due to high CPU workload on the Security Gateway, the security administrator decided to purchase a new CPU to replace the existing single core CPU. After installation, is the administrator required to perform any additional tasks?

Go to clash-Run cpstop | Run cpstart

Go to clash-Run cpconfig | Configure CoreXL to make use of the additional Cores | Exit cpconfig | Reboot Security Gateway

Administrator does not need to perform any task. Check Point will make use of the newly installed CPU and Cores

Go to clash-Run cpconfig | Configure CoreXL to make use of the additional Cores | Exit cpconfig | Reboot Security Gateway | Install Security Policy

NO.199 SSL Network Extender (SNX) is a thin SSL VPN on-demand client that is installed on the remote user’s machine via the web browser. What are the two modes of SNX?

Application and Client service

Network and Application

Network and Layers

Virtual Adapter and Mobile App

NO.200 Which process handles connection from SmartConsole R80?

fwd

cpmd

cpm

cpd

NO.201 You noticed that CPU cores on the Security Gateway are usually 100% utilized and many packets were dropped. You don’t have a budget to perform a hardware upgrade at this time. To optimize drops you decide to use Priorities Queues and fully enable Dynamic Dispatcher. How can you enable them?

fw ctl multik dynamic_dispatching on

fw ctl multik dynamic_dispatching set_mode 9

fw ctl multik set_mode 9

fw ctl multik pq enable

NO.202 Which of the following is NOT a valid type SecureXL template?

Accept Template

Deny template

Drop Template

NAT Template

NO.203 What is the recommended number of physical network interfaces in a Mobile Access cluster deployment?

4 Interfaces – an interface leading to the organization, a second interface leading to the internet, a third interface for synchronization, a fourth interface leading to the Security Management Server.

3 Interfaces – an interface leading to the organization, a second interface leading to the Internet, a third interface for synchronization.

1 Interface – an interface leading to the organization and the Internet, and configure for synchronization.

2 Interfaces – a data interface leading to the organization and the Internet, a second interface for synchronization.

NO.204 Which is NOT an example of a Check Point API?

Gateway API

Management API

OPSC SDK

Threat Prevention API

NO.205 Which statement is not TRUE about Default synchronization?

Using UDP Multicast Broadcast on port 8161

Using UDP Multicast on port 8116

Quicker than Full sync

Transfer changes in the kernel tables between cluster members

NO.206 What kind of information would you expect to see using the sim affinity command?

The VMACs used in a Security Gateway cluster

The involved firewall kernel modules in inbound and outbound packet chain

Overview over SecureXL templated connections

Network interfaces and core distribution used for CoreXL

NO.207 Which is the least ideal Synchronization Status for Security Management Server High Availability deployment?

Synchronized

Never been synchronized

Lagging

Collision

NO.208 What SmartEvent component creates events?

Consolidation Policy

Correlation Unit

SmartEvent Policy

SmartEvent GUI

NO.209 What is the command to check the status of the SmartEvent Correlation Unit?

fw ctl get int cpsead_stat

cpstat cpsead

fw ctl stat cpsemd

cp_conf get_stat cpsemd

NO.210 For Management High Availability, which of the following is NOT a valid synchronization status?

Collision

Down

Lagging

Never been synchronized

NO.211 Fill in the blank: The R80 utilityfw monitoris used to troubleshoot ________.

User data base corruption

LDAP conflicts

Traffic issues

Phase two key negotiations

NO.212 During Inspection of your Threat Prevention logs you find four different computers having one event each with a critical Severity. Which of those host should you try to remediate first?

Host having critical event found by Threat Emulation IS.

Host having critical event found by IPS

Host having critical event found by Antivirus

Host having critical event found by Anti-Bot

NO.213 An administrator is creating an IPsec site-to-site VPN between his corporate office and branch office. Both offices are protected by Check Point Security Gateway managed by the same Security Management Server. While configuring the VPN community to specify the pre-shared secret the administrator found that the check box to enable pre-shared secret and cannot be enabled.
Why does it not allow him to specify the pre-shared secret?

IPsec VPN blade should be enabled on both Security Gateway.

Pre-shared can only be used while creating a VPN between a third party vendor and Check Point Security Gateway.

Certificate based Authentication is the only authentication method available between two Security Gateway managed by the same SMS.

The Security Gateways are pre-R75.40.

NO.214 When SecureXL is enabled, all packets should be accelerated, except packets that match the following conditions:

All UDP packets

All IPv6 Traffic

All packets that match a rule whose source or destination is the Outside Corporate Network

CIFS packets

NO.215 Which is NOT an example of a Check Point API?

Gateway API

Management API

OPSC SDK

Threat Prevention API

NO.216 What will SmartEvent automatically define as events?

ファイアウォール

かそうへいいきもう

IPS

HTTPS

NO.217 To ensure that VMAC mode is enabled, which CLI command should you run on all cluster members?

fw ctl set int fwha vmac global param enabled

fw ctl get int vmac global param enabled; result of command should return value 1

cphaprob-a if

fw ctl get int fwha_vmac_global_param_enabled; result of command should return value 1