NO.44 You ate the NACE Inspector on a job where NACE No. 2/SSPC – SP 10 has been specified. You are finding the Contractor is leaving mill scale on the on surface and as a result you have been rejecting the blast. The Contractor is very upset and has told you that the standard permits up to 5% of the mill scale to remain and still be in be in compliance with the standard.
您的首选行动方案是：

第 45 号 As a NACE Coating Inspector your responsibility with respect to safety is to:

第 46 号 需要进行假日测试时，检查员必须始终执行 NACE SP 0188：

NO.47 Daily reports are important because:
Select All That Apply

第 48 号 You have just received your NACE CIP Level 1 certification when you are asked to supervise a team of uncertified field pipeline inspectors.
您的首选行动方案是：

NO.49 You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining.
您的首选行动方案是：

NO.50 Galvanic corrosion occurs on which of the following substrates:

第 51 号 Using SSPC Vis 1 as a guide when performing a visual inspection of a steel surface prior to surface preparation a NACE Inspector would assign which designations to the surface condition:

第 52 号 在使用检查工具之前，检查员必须

第 53 号 A NACE Coating Inspector is permitted to transport coating material when:

第 54 号 SSPC-PA 2 要求在直径为 4 厘米（1.5 英寸）的圆圈内读取多少个量规读数？

第 55 号 What is used to determine compressed air cleanliness?

NO.56 You are the NACE Coating Inspector on an exterior job where the contractor is not using any environmental controls, For the last several hours your reading; indicate the relative humidity is rising and the substrate temperature is dropping. The sky is clouding over and the weather forecast is for evening showers. It is now 4 PM, your readings indicate you have minimally acceptable environmental conditions, however if the current trend continues, you expect to be outside specified conditions soon. The contractor advises you he is going to mix up the next full kit to complete his for the day.
Your FIRST preformed course of action is to:

NO.57 Dew point is the temperature at which

NO.58 Common errors that can produce inaccurate readings when using Wet Film Thickness (WFT) gauges include:
Select All That Apply

第 59 号 In the event of a conflict between the project specification and the coating manufactures’ product data sheet, the Inspector’s first course of action should be too:

NO.60 To achieve consistently accurate results with ALL alt test equipment

第 61 号 ISO SA 3 直接等同于

第 62 号 涂层表面的细微裂纹很少到达基底，这种裂纹被称为

NO.63 Inspection documentation is important because:

NO.64 Which is a component that supplies most of the features and functions of the material?